FastBrick

Tender/Lifeboat, Page 8

Back to Page 1    Back    Next Page

After consulting with Phil Bolger, it was decided to sheath the interior of the boat with fiberglass cloth and epoxy in order to make a really tough, long lasting surface.  This view shows  the boat up on her side, getting glassed on the starboard interior side.  The bottom of the interior has already been done, save for sanding and fairing.

 

While I had her up on her sides, I sanded and faired the exterior of the opposite side, since this is the best way to get fairing compound (epoxy thickened with phenolic microballoons) onto the surface.  At the same time, the thwart risers were installed on the inside.

 

 

 

 

Back to Page 1    Back    Next Page